Multiplexing

When two communicating nodes are connected through a media, it generally happens that bandwidth of media is several times greater than that of the communicating nodes. Transfer of a single signal at a time is both slow and expensive. The whole capacity of the link is not being utilized in this case. This link can be further exploited by sending several signals combined into one. This combining of signals into one is called multiplexing.

1. Frequency Division Multiplexing (FDM): This is possible in the case where transmission media has a bandwidth than the required bandwidth of signals to be transmitted. A number of signals can be transmitted at the same time. Each source is allotted a frequency range in which it can transfer it's signals, and a suitable frequency gap is given between two adjescent signals to avoid overlapping. This is type of multiplexing is commonly seen in the cable TV networks. 

     2. Time Division Multiplexing (TDM): This is possible when data transmission rate of the media is much higher than that of the data rate of the source. Multiple signals can be transmitted if each signal is allowed to be transmitted for a definite amount of time. These time slots are so small that all transmissions appear to be in parallel. 

• Synchronous TDM: Time slots are preassigned and are fixed. Each source is given it's time slot at every turn due to it. This turn may be once per cycle, or several turns per cycle ,if it has a high data transfer rate, or may be once in a no. of cycles if it is slow. This slot is given even if the source is not ready with data. So this slot is transmitted empty. 

• Asynchronous TDM: In this method, slots are not fixed. They are allotted dynamically depending on speed of sources, and whether they are ready for transmission.